172
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
Recovery method
II
If the instrument pack software update fails and usage of the integrated interface is required (not
using a mobile device or the PC-based interface), the IIDTool will no longer be able to write on the ins-
trument cluster screen. Also, the engine won’t start. The following steps will allow retrying the software
update without having access to the IIDTool’s menu.
• Disconnect your IIDTool and turn the key to the OFF position.
• Turn the key to the ON position and connect your IIDTool.
• Wait until the IIDTool LED turns and stays ON.
• Press the down/lower button of the suspension height selector on the centre console. Hold the
button until the LED turns OFF (approximately 12 seconds).
• After a few seconds, the software update will begin and the LED will start flashing. The process
takes around one minute. When finished, the Instrument Pack will turn ON.
• Once the instrument pack turns ON, wait a few seconds and cycle the key from the OFF to the
ON position.
App
Simply repeat the reflashing steps.
You can now use your IIDTool and vehicle normally.
If the recovery method was not successful, please contact the manufacturer for additional support :
.
