Fukuda Denshi Dynascope 8000 Series, Руководство по обслуживанию

Страница: 58 / 154

2-6
Chapter 2 Network System Construction Wireless Network
Wireless Network
In this section, connection and setup procedure for wireless network is explained.
By constructing a wireless network using the optional telemetry unit, the data on this monitor can be transmitted to
the central monitor.
WARNING

On a wireless network, the alarm generated on the bedside monitor will be output to the
network with a maximum delay of 2 seconds, and to the central monitor with a total delay of
3 seconds to 12 seconds.

Some type of wireless combinations may generate interference with other telemetry.

Before selecting a channel, verify it will not interfere with other channels.

Make sure the telemetry manager of your system is aware of any changes to the telemetry
channels.

If transmitters are used in a neighboring medical facility, your facility and the neighboring
facility must make agreements on the setting of the telemetry channels to prevent telemetry
interference.
Example of Wireless Network Construction
CAUTION

The setup of channel ID and group ID should be performed only by our service
representative. Users should not perform this procedure as malfunction may occur.
1 Bedside Monitor
DS-8007 System with HLX-801
2 Central Monitor
DS-7700 system
3 Central Monitor
DS-8900 system with LW Receiver
Channel ID and Telemetry Wave Setup
In this section, channel ID and telemetry wave setup when using the telemeter is explained.
Once the transmitting channel ID and group ID are set, these will be retained even after the main power is turned
OFF.
WARNING

A password can be set to restrict access to the channel ID setup menu so that only the
telemetry channel administrator can change the channel ID.

Some type of wireless combinations may generate interference with other telemetry.

Before selecting the wireless channel, verify it does not cause interference.
2
3
1