Point
It is recommended that you back up the system before starting the upgrade.
By preparing a backup, in cases when an error occurs during the upgrade, it is possible to return the system to its state prior to the
upgrade, simply by recovering (restoring) the system from the backup.
1.
Login to the server on which to perform the tasks. Perform operations after logging in with root (superuser).
2.
Ensure that there is enough available disk space (200 MB) on the server where the upgrade is performed.
Note that in cases when upgrade installation is executed in a state where the capacity required for the upgrade is not available,
the following message is displayed and the installation terminates in an error. Re-execute the upgrade after securing the
capacity required for the installation.
Output Message (in cases when the directory of the destination of the installation is /opt):
ERROR:Disk /opt has an insufficient free space. Please execute it again after increasing the disk
area.
3.
Execute the following command to stop the ETERNUS SF Manager daemon.
# /opt/FJSVesfcm/bin/stopesf.sh
4.2.2 Performing Upgrade
Refer to "
" and perform the Upgrade Installation.
Point
If the Upgrade Installation has ended in an error, after removing the cause of the failure of the Upgrade Installation, re-execute the
installation from the execution of the installation shell.
4.2.3 Tasks to Be Performed After Upgrade
The tasks below need to be performed.
1.
In the version level of this ETERNUS SF Manager, Symfoware is not used.
To upgrade from Version 16.1 or later, the procedures listed below are not needed.
To upgrade from Version 16.0 or earlier, follow the procedures listed below to uninstall the Symfoware Server.
a.
Confirm that other products are not utilizing the Symfoware. If Symfoware is in use by another product, refrain from
uninstalling Symfoware.
b.
Start the uninstaller of Symfoware to delete the Symfoware package.
# /opt/symfoware/setup/symfo_remove
c.
Confirmation message to uninstall Symfoware is displayed. To perform the uninstallation, enter "y". To cancel the process,
enter "q".
When "y" is entered, a message allowing to select the function to uninstall is shown. Input "all" or "number to delete" to
select the function to uninstall.
A message to re-confirm uninstallation appears. Enter "y" to perform the uninstallation and "q" when it is not required.
Example of Uninstallation with the Specification "all"
Start checking the installation environment.
Check of installation environment is ended.
WARNING: There is a possibility that another product uses "Symfoware Server Enterprise
Edition".
- 25 -