3.
Execute the following silent installation command.
For
installLogFile
, specify the file in which to output installation log with an absolute path. It is optional to specify for
installLogFile
.
<dvdromDrive>:\Manager_windows\esfsilentinstall_ccm.bat -eula agreed [-l <installLogFile>]
Point
-
The -eula option is specified to agree to licensing. Only when "agreed" is specified for option parameter is installation
enabled. The -eula option must be specified before other options.
-
If nothing is specified for
installLogFile
, an install log file named "esfsilentinstall.log" is created in the working directory
specified by the environment variable TEMP.
-
If there is any file of the same name as the specified install log file, it is overwritten.
-
It is required to specify an existing directory with write permission for the directory in which to store the install log file. If it
has no write permission, no error message is output in the command prompt or screen and the process terminates with error.
-
If the paths to the install log file contain any spaces, they should be surrounded by double quote characters.
-
The characters " | : * ? / . < > , % & ^ ; ! are not supported for path name for install log file.
Note
-
If an invalid option is specified, its corresponding error message is output in the install log file and the process exits. No error
message is output in the command prompt or screen.
-
Do not execute multiplexly the command for silent installation. If it is multiplexly executed, the command executed after
that terminates abnormally. At this time, an install log file is not created.
-
During an update, it is not possible to specify an installation parameter file for the command. In the case that a file has been
specified, the command terminates in an error.
4.
On completion of installation, a command prompt is displayed.
Remove the DVD-ROM media used for installation out of the device.
Confirming the Results of the Silent Upgrade Installation
Check the return value from the silent installation command. If necessary, check the install log file. However, if the return value from
the silent installation command is 3 or 9, an install log file is not created. For details, refer to "Return Values for Silent Installation (for
ETERNUS SF Manager, AdvancedCopy Manager CCM)" in the
ETERNUS SF Installation and Setup Guide
.
The installation result can be viewed in the install log file, too.
Open the install log file to see "ResultCode" in the ResponseResult section. In "ResultCode" is written the return value from the silent
installation command.
The upgrade is complete above.
Return to the section where this item was referenced to continue tasks.
C.8 Procedures for Upgrade Installation of AdvancedCopy Manager
Copy Control Module Version 16.x (for Solaris, Linux)
For the Upgrade Installation, there is an installation method where required information is entered interactively and a method where
no questions are asked (silent upgrade installation).
If you perform the interactive method, refer to "
" and if you perform the silent method, refer to "
Performing Upgrade with Silent Installation Procedure
- 351 -
