Installation Procedure
83
Using E-
Mai
l Ser
v
ice
10
3) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual] and then
select [Save]. If you select anything other than [Manual], proceed to step 4.
Note
•
When using a DHCP server, also configure the WINS (Windows Internet Name Service)
server.
4) Select [TCP/IP - Get IP Address] and select [Change Settings].
5) Enter the IP address using the numeric keypad.
Note
•
Enter address in the format "xxx.xxx.xxx.xxx". xxx should be a numeric value in the range
from 0 to 255. However, the first xxx cannot be 127 or any value between 224-255.
•
When you make an entry mistake, press the <C> (Clear) button and enter again.
•
When you would like to move to next without entering all 3 digits, select [save/select next].
6) Select [Save].
7) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.
Note
•
Enter address in the format "xxx.xxx.xxx.xxx". xxx should be a numeric value in the range
from 0 to 255. However, the first xxx cannot be 127 or any value between 224-255.
•
Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 248, 252, and
255. However, you cannot use 0 between non-zero values.
•
If you do not wish to set the gateway address, enter "0.0.0.0".
4
Select [Close] repeatedly until the [System Settings] screen is displayed.
5
Select [Exit].
6
After the machine is restarted, print out the [Printer Settings List] to confirm that the
ports are enabled and TCP/IP is configured.
For information about how to print a setting list, refer to [Print Report/List] in Chapter 12 of the User
Guide.
Configuring E-mail Environment
The following describes the configuration procedure to use the e-mail feature.
Note
•
The configuration can also be performed using CentreWare Internet Services.
Refer to "Using CentreWare Internet Services" (P.55) for how to use CentreWare Internet Services.
1
Display the [System Administrator Menu] screen.
1) Press the <Log In/Out> button.
2) Enter the User ID with the numeric keypad or a keyboard displayed by pressing
[Keyboard], and select [Confirm].
Note
•
The default User ID value is "11111". When using the Authentication feature, a password is
required. The default password is "x-admin".
3) Select [System Settings].
2
Set the e-mail address, host name, and domain name.
1) Select [System Settings].
2) Select [Network Settings].
3) Select [Machine E-mail Address/Host Name].
4) Select [E-mail Address] and then select [Change Settings].
5) Enter the [E-mail Address] using the keyboard displayed.
6) Select [Save].
7) Set the [Host Name] and [Domain Name] as above.
8) Select [Close].
