11 Using Scan Service
100
U
sin
g
Sca
n
Ser
vice
11
2) Select [Network Settings].
3) Select [Port Settings].
4) Select [SNMP] and then select [Change Settings].
5) Select [Port Status] and select [Change Settings].
6) Select [Enabled] then select [Save].
7) Select [Close] repeatedly until the [Port Settings] screen is displayed.
8) Enable the FTP client port and Internet service (HTTP) port as above.
9) Select [Close] repeatedly until the [Network Settings] screen is displayed.
3
Set an IP address
If the IP address is already set, this step is not necessary. Also, in an environment with
DHCP or BOOTP, configure the way to obtain the address. Either the address cannot
be obtained automatically or manual configuration is preferred, configure the IP
address, subnet mask, and gateway address.
1) Select [Close] repeatedly until the [Network Settings] screen is displayed.
2) Select [Protocol Settings].
3) Select [TCP/IP - Get IP Address] and then select [Change Settings].
4) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual]. If you
select anything other than [Manual], proceed to step 6.
Note
•
When using a DHCP server, also configure the WINS (Windows Internet Name Service)
server.
5) Select [TCP/IP - Get IP Address] and then select [Change Settings].
6) Enter the IP address using the numeric keypad.
Note
•
Enter address in the format "xxx.xxx.xxx.xxx". xxx should be a numeric value in the range
from 0 to 255.However, the first xxx cannot be 127 or any value between 224-255.
•
When you make an entry mistake, press the <C> (Clear) button and enter again.
•
When you would like to move to next without entering all 3 digits, select [save/select next].
7) Select [Save].
8) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.
Note
•
Enter address in the format "xxx.xxx.xxx.xxx". xxx should be a numeric value in the range
from 0 to 255. However, the first xxx cannot be 127 or any value between 224-255.
•
Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252,
254 and 255. However, you cannot use 0 between non-zero values.
•
If you do not wish to set the gateway address, enter "0.0.0.0".
4
Select [Close] repeatedly until the [System Settings] screen is displayed.
5
Select [Exit].
6
After the machine is restarted, print out the [Printer Settings List] to confirm that the
ports are enabled and TCP/IP is configured.
For information about how to print a setting list, refer to [Print Report/List] in Chapter 12, [Machine
Status], of the User Guide.
