freightliner Sprinter 2020, Руководство по эксплуатации

Страница: 129 / 344

Electronic level control starts automatically if the
ignition is switched on. Operation is only possible
after the parking brake has been applied.
Electronic level control performs a self-check reg‐
ularly when it is activated and while in use. Indi‐
cator lamp 7 on the remote control lights up for
about one second when you switch on the igni‐
tion.
There is a malfunction if indicator lamp
7
behaves in the following ways:
R
The indicator lamp does not light up when you
switch on the ignition.
or
R
The indicator lamp then lights up again or
flashes.
In addition, a warning tone is emitted from the
remote control for approximately 30 seconds.
The fault that has been detected can be shown
using the indicator lamps (signaling of fault
codes).
#
Park the vehicle, leaving the ignition switched
on.
#
Apply the parking brake.
#
To raise or lower the vehicle level: press
and hold button 4 or 5 until the vehicle
level reaches the required height.
The indicator lamp in button 4 or 5 flashes
as long as the vehicle level is being changed.
When the vehicle level has been set, the indi‐
cator lamp in button 4 or 5 lights up.
#
To lower automatically: briefly press button
5 .
Electronic level control automatically lowers
the vehicle to the next lower position:
R
From the highest position to driving level
R
From driving level to the lowest position
The indicator lamp in button 5 flashes as
long as the vehicle level is being changed.
When the vehicle level has been set, the indi‐
cator lamp in button 5 lights up.
% By pressing button 4 during the movement,
the original position will be reset.
#
To raise automatically: briefly press button
4 .
Electronic level control automatically raises
the vehicle to the next higher position:
R
From the lowest position to driving level
R
From driving level to the highest position
The indicator lamp in button 4 flashes as
long as the vehicle level is being changed.
When the vehicle level has been set, the indi‐
cator lamp in button 4 lights up.
%
By pressing button 5 during the movement,
the original position will be reset.
#
To raise or lower automatically to driving
level (center position): press and hold but‐
ton 6 .
Electronic level control automatically raises or
lowers the vehicle to driving level.
#
To save the set vehicle level: set the
required vehicle level.
#
Press and hold button 1 or 2 until you hear
a tone.
The vehicle level set has been saved on corre‐
sponding button 1 or 2 .
#
To call up the saved vehicle level: briefly
press button 1 or 2 .
Electronic level control automatically raises or
lowers the vehicle to the saved driving level.
The indicator lamp in button
1 or 2 flashes
as long as the vehicle level is being changed.
When the vehicle level has been set, the indi‐
cator lamp in button 1 or 2 lights up.
%
Service mode may only be activated or deac‐
tivated at a qualified specialist workshop by
trained personnel. In service mode, the air
suspension system is deactivated for mainte‐
nance or fault detection.
#
To activate service mode: press button 3 .
Service mode is active and the indicator lamp
in button 3 lights up continuously.
#
To deactivate service mode: press button
3 .
Service mode is deactivated and the indicator
lamp in button 3 goes out.
Driving and parking 127