freightliner Sprinter 2020, Руководство по эксплуатации

Страница: 233 / 344

#
Ensure floor mats and carpets cannot
slip and provide sufficient room for the
pedals.
#
Do not lay multiple floor mats or carpets
on top of one another.
#
Switch off all electrical consumers.
#
To remove: unscrew screws 3 and remove
trim 2 .
#
Remove floor covering 1 .
#
To install: insert floor covering 1 and align
it at the base of the driver's seat and at the
door sill.
#
Put trim 2 in place and screw screws 3
back in.
Disconnecting the starter battery
*
NOTE Damage to electrical assemblies
Electrical assemblies could be damaged if the
starter battery is disconnected while the
engine is running.
#
Switch off the engine. Then, release the
battery clamps of the starter battery.
#
Always disconnect the starter battery in
the battery case in the left footwell first.
Otherwise, electrical assemblies, e.g.
the alternator, could be damaged.
* NOTE Damage to the vehicle's electron‐
ics
If you do not disconnect the battery as descri‐
bed here, the vehicle's electronics could be
damaged.
#
Always disconnect the starter battery in
following the sequence, and do not
reverse the battery terminals under any
circumstances. Otherwise, the vehicle's
electronics could be damaged.
Vehicles with rear wheel drive
% If the vehicle is expected to be parked for an
extended period or out of use for longer than
four weeks, observe the information on park‐
ing the vehicle for an extended period
(
/
page 141).
#
Vehicles with a battery main switch:
remove the main switch of the battery
(
/
page 118).
#
Vehicles without a battery main switch:
switch off all electrical consumers.
#
Switch off the engine and the power supply.
#
Remove the floor covering (
/
page 230).
#
Remove screws 1 and slide battery cover
2 in the direction of the arrow.
The screws must protrude over the larger
recesses.
#
Remove battery cover 2 upwards.
Breakdown assistance 231