Only use the middle rod and the pump lever rod
with the largest diameter for the jack as a lug
wrench extension. Only insert the middle rod on
the lug wrench, and always as far as it will go.
Otherwise, the rods could bend and deform so
much that they can no longer be used as pump
levers for the jack.
#
To prepare the hydraulic jack: insert the
third rod of pump lever
1
for the jack into
the lug wrench extension.
#
Close pressure release screw
3
.
#
To do this, use the flattened section on pump
lever
1
to turn pressure release screw
3
clockwise to the stop.
%
Do not turn pressure release screw
3
more
than one or two full turns. Hydraulic fluid
could otherwise escape.
#
Insert pump lever
1
with the largest rod into
the recess on the jack and secure by turning
it clockwise.
#
Place the jack vertically beneath the jack sup‐
port points described below.
Jack support point, front axle
Jack support point, rear axle (example: chassis
up to 3.5 t)
Jack support point, rear axle (example: Cargo
Van and Passenger Van up to 4.0 t)
262 Wheels and tires
Содержание Sprinter 2020
Страница 7: ......
Страница 18: ...ASpare wheel example 265 16 At a glance Emergencies and breakdowns...