freightliner Sprinter 2020, Руководство по эксплуатации

Страница: 85 / 344

The function is active under the following condi‐
tions:
R
The speed is less than 37 mph (60 km/h) and
the indicator has been switched on or the
steering wheel is turned.
R
The speed is between 37 mph (60 km/h) and
50 mph (80 km/h) and the steering wheel is
turned.
The cornering light may still light up for a short
time but is switched off automatically after a
maximum of three minutes.
%
When reverse gear is engaged, the lighting
switches to the opposite side.
Highbeam Assist
Adaptive Highbeam Assist function
&
WARNING Risk of accident despite
Adaptive Highbeam Assist
Adaptive Highbeam Assist does not recognize
the following road users:
R
Road users without lights, e.g. pedes‐
trians
R
Road users with poor lighting, e.g. cyclists
R
Road users whose lighting is obstructed,
e.g. by a barrier
On very rare occasions, Adaptive Highbeam
Assist may fail to recognize other road users
with their own lighting, or may recognize
them too late.
In these or similar situations, the automatic
high beam is not deactivated or is activated
despite the presence of other road users.
#
Always observe the traffic carefully and
switch off the high beam in good time.
The Adaptive Highbeam Assist automatically
switches between the following settings:
R
Low beam
R
High beam
The system detects that vehicle lights are
approaching in the opposite direction or driving
ahead of the vehicle.
At speeds greater than 19 mph (30 km/h), a
change is made to the following setting:
R
If no other road users are detected, the high
beam switches on automatically.
At speeds less than 16 mph (25 km/h) or if there
is sufficient road lighting, a change is made to
the following setting:
R
The high beam automatically switches off.
System limitations
Adaptive Highbeam Assist cannot take the road,
weather or traffic conditions into consideration.
The detection of obstacles can be restricted if:
R
Visibility is impaired, e.g. in fog, heavy rain or
snow
R
The sensors are dirty or covered
Adaptive Highbeam Assist is only an aid. You are
responsible for ensuring correct vehicle lighting
in accordance with the prevailing light, visibility
and traffic conditions.
The system's optical sensor is located behind the
windshield near the overhead control panel.
Switching Highbeam Assist on or off
#
To switch on: turn the light switch to the
à position.
#
Switch the highbeam on using the combina‐
tion switch.
If the highbeam is automatically switched on
in darkness, the _ indicator lamp on the
multifunction display lights up.
#
To switch off: switch off the highbeam using
the combination switch.
Setting the exterior lighting switch-off delay
time
Requirements:
R
The light switch is in the à position.
Multimedia system:
4
©
5
Settings
5
Light
5
Exterior Lighting Delay
#
Set a switch-off delay time.
When the vehicle engine is switched off, the exte‐
rior lighting will be activated for the set time.
Light and vision 83