Franklin Electric CERUS X-DRIVE CXD-003A-4V, Инструкция по установке и эксплуатации

Страница: 170 / 252

MAINTENANCE
Troubleshooting
170
CSbn
(44)
CAN/S Buf over
CANopen SDO receives register overflow
Action and Reset
Action condition The upper unit sends too much SDO and causes buffer overflow
Action time Immediately displays when the fault is detected
Reset method Automatically
Reset condition The upper unit sends a reset package to clear the warning.
Recorded N/A
Possible Causes Corrective Action
• Too much SDO from the upper unit • Check if the master sends too much SDO command. Make sure the master sends SDO command
according to the command format.
Warning Display Description
CSdn (43)
CAN/S SDO T-out
SDO transmission time-out (only shows on master station)
Action and Reset
Action condition When the CANopen master transmits SDO command, and the Follower response “time-out”, CSdn warning will occur.
Action time Immediately displays when the fault is detected
Reset method Automatically
Reset condition When the master resends a SDO command and receives the response, the warning clears.
Recorded N/A
Possible Causes Corrective Action
Warning Display Description
dAvE
(18)
Deviation Warn
Over speed deviation warning
Action and Reset
Action condition N/A
Action time N/A
Reset method Automatically
Reset condition After the drive stops
Recorded N/A
Possible Causes Corrective Action
• Improper parameter setting for the slip
error
• Improper setting for ASR parameter and
acceleration/deceleration
• Accel./ Decel. time is too short
• Motor locked
• Incorrect parameter setting of torque
limit
• Malfunction caused by interference
• Reset ASR parameters. Then set proper accel./ decel. time.
• Reset proper accel./ decel. time.
• Remove the causes of motor locked.
• Check the active timing of the system.
• Adjust to proper setting value.
• Verify wiring of the control circuit, and wiring/grounding of the main circuit to prevent interference.
Warning Display Description