Foma F905I, Руководство пользователя, Страница: 53 / 532

51
Voice/Videophone Calls
Sending tone signal (DTMF)
Tone signals (DTMF) can be sent from FOMA terminal to
operate the Voice Mail service or use various push-
button phone services at your home. By entering pause
("P") or timed pause ("T") when making a voice call, tone
signals (DTMF) can be sent with digits in the phone
number separated.
･
Pause and timed pause are enabled only for voice calls.
❖
Entering pause "P"
Use for operating the answering system at home,
reserving tickets, etc. Tone signals are sent with the
phone number separated at the point where pause ("P") is
entered.
1
Enter a phone number
e
*
(1 sec. or
more)
e
Enter digits to send
e
n
When pressing
g
after the call is connected, the
digits after the pause ("P") are sent.
❖
Entering timed pause "T"
Timed pause ("T") is used to dial outside line number
followed by an extension. When timed pause ("T") is
entered between the phone and extension numbers, the
extension number is dialed with a pause of the
predetermined seconds after the phone number is dialed.
1
Enter a phone number
e
#
(1 sec. or
more)
e
Enter an extension number
e
n
･
Timed pauses ("T") can be entered in succession.
･
Each timed pause ("T") is followed by an interval
of approximately 1 second.
❖
Sending tone signal (DTMF) during a
videophone call
･
The tone signal can be entered only while sending
camera image, while sending Camera-Off image or
while Chara-den is displayed.
1
During a call,
m
e
0
e
Enter digit to
send
The number you pressed is displayed and the tone
signal is transmitted.
c
: Cancel sending
･
While sending camera image or Camera-Off
image, a tone signal can be sent only by pressing
the keypad without pressing
m0
.
･
A frame set on a camera image or a still image set
as a substitute image is canceled.
･
Because a tone signal is sent using keypads,
actions with pressing keypads are disabled while
sending Chara-den.
✔
INFORMATION
･
Tone signals may not be received depending on the
receiving device.
･
You cannot make a call to another party, putting the current
call on hold, by entering a pause ("P") or timed pause ("T").
Call option
Making a call under set conditions
You can set calling conditions each time you make a
voice or videophone call.
･
Making PushTalk calls using after setting Caller ID
notification
→
P68
･
Priority of the method to notify a caller ID → P41
1
Enter a phone number
e
m
e
2
e
Set
the required items
Chaku-moji : Create or select a message to be sent
to the other party. → P49
Multi-No/Own number : Select the caller ID.
･
Call type of Multi number → P377
･
With 2in1 ON in Dual or B mode, "Own number"
appears. In Dual mode, select "Number A" or
"Number B".
→
P377
Call type : Select any of "Voice call", "V.phone",
"PushTalk" or "SMS".
Caller ID : Set Notify/Not notify for a caller ID. When
"Unspecified" is set, the settings in Caller ID
notification are used.
Prefix : Select Prefix to be added before phone
number.
Intn'l call : Set whether to make an international call.
→ P53
Intn'l prefix : Select International prefix number
when making an international call.
Blinking