FLIR Quasar CB-6404, Инструкция по установке и эксплуатации

Страница: 61 / 87

Configuration
CB-640x Installation and User Guide Revision 100 February 2021 53
This document does not contain any export-controlled information.
Figure 61: Rule Configuration Trigger Screen - I/O Trigger Selected
2.
Rule name
: Specify a unique and useful name for the rule.
3. Select the type of trigger event:
• VMD : Select whether Motion detection or Tampering triggers an alarm.
When Motion is selected, specify the motion Sensitivity ( 1 - 100 ). When Tampering is selected,
specify the tampering
Sensitivity
(
High
,
Mid
,
Low
).
Note
If you are defining a Motion alarm rule, make sure a motion detection zone has been defined
and enabled on the Motion Page .
• I/O :
o Select the type of input that triggers an alarm:

Alarm
: Select the
Type
; that is, whether the input is Normally Open or Normally
Closed.

Audio
: Specify the
Sound Intensity Threshold
(0-100); lowering the value
increases the camera’s sensitivity to audio input, and vice versa.
• System
: Select the type of system event that triggers an alarm:
o Network Loss
o Network Conflict
o Schedule : The camera triggers an alarm or alarms according to a specified schedule.
When selected, specify the alarm schedule
Mode
:

Regular
: The camera triggers an alarm at regular intervals. When selected,
specify the Trigger Interval (Sec) , the frequency at which the camera triggers an
alarm, in seconds between
5-3600
(
3600
= once per hour).

Persist
: The camera triggers a persistent alarm.
4. Click Next . The rule configuration Schedule screen appears.