Installation
CB-640x Installation and User Guide Revision 100
February 2021
14
This document does not contain any export-controlled information.
Interface
Description
5 STATUS
LED (green / red / amber) that indicates camera is booting up or firmware
being upgraded.
Camera state
LED state
Description
Booting up
Solid red
for 2-3
seconds,
then:
Green
Normal
After a successful boot,
the LED turns off after
three minutes.
Red
An error has occurred.
Firmware
upgrade
Flashing amber
During upgrade
6 Safety wire
Makes sure the access cover does not drop. To ensure that the camera
remains waterproof, store the safety wire inside the camera before locking
the access cover.
3.5 Powering the Camera
The camera can be powered by PoE or by an external DC or AC power supply (not included in the
camera kit). The following diagram shows how the camera can be powered using PoE.
Figure 10: PoE Connection
Caution
•
When powered by PoE, this product must be connected only to a PoE network.
•
The PoE supply’s rated output is 48VDC, 0.2A.
•
If the camera is installed for outdoor use, the PoE supply must be installed with proper
weatherproofing.
•
As a Listed Power Unit, the PoE should be marked as “LPS” or “Limited Power Source”.
•
This product shall be installed by a qualified service person. Installation shall conform to all
local codes.