Configuration
CB-640x Installation and User Guide Revision 100
February 2021
45
This document does not contain any export-controlled information.
o
IPv4 Subnet Mask
: Determines whether destinations are on the same subnet. FLIR
recommends using the default address: 255.255.255.0. If the subnet mask is not properly
configured, the camera might not be able to communicate with other devices on the network.
o
IPv4 Default Gateway
: Used to forward frames to destinations in other subnets. An invalid
gateway setting causes transmission to destinations in other subnets to fail.
o
Primary DNS
: Specify the primary domain name server (DNS) address.
o
Secondary DNS
: Specify the secondary DNS address.
•
PPPOE
: The camera connects to the network via a DSL modem using Point-to-Point Protocol over
Ethernet (PPPOE). Manually specify the
User Name
and
Password
for the PPPOE account.
IPv6 Enable
: If you are using IPv6, move the slider to the right to enable IPv6, and then configure:
•
Accept IPv6 Router Advertisement
– Move the slider to the right to accept IPv6 router advertisement.
By default,
Accept IPv6 Router Advertisement
is disabled.
•
Enable DHCPv6
: If the camera is connected to a network with a DHCP server that supports IPv6
addressing, move the slider to the right. By default, DHCPv6 is disabled.
If IPv6 is enabled, but DHCPv6 is disabled, manually specify the camera’s:
•
IPv6 Address
: Identifies the camera on the network.
Subnet Prefix Length
: Specify the subnet prefix
length (1-128 digits).
•
IPv6 Default Router Address
: Specify the IPv6 default router address.
Subnet Prefix Length
: Specify
the subnet prefix length (1-128 digits).
•
IPv6 DNS
: Specify the IPv6 DNS address.
Figure 47: QoS Settings
Enable QoS
(Quality of Service): Determines resource control and traffic prioritization according to
priority assigned to applications or users, assuring a certain level of data flow performance. If you are
using QoS, move the slider to the right to enable it. You can then separately configure the following for
QoS Priority 1
and
2
:
•
IPv4 Address
: Specify an IPv4 address for each QoS priority level.
•
Netmask Bit
: Specify a value between
0-32
for each QoS priority level.
