Fayat Bomag CR 820 T Tier 4, Инструкция по эксплуатации, Инструкция по техническому обслуживанию

Страница: 105 / 130

9 Maintenance
Date May 2020
Page 9-7
Operations Manual
CR 820 T
Wait at least 5 minutes after shutting off the engine
to check the oil. This allows time for the oil to drain
to the oil pan.
Remove the dipstick (1).
Wipe off any oil with a cloth.
Reinsert the dipstick.
Maintain the oil level between the high and low
levels marked on the dipstick.
Change Engine Oil and Filter
The engine oil and filter should be changed at least
every 250 hours of operation. Shorter intervals may
be required due to operational conditions. Severe
conditions require more frequent maintenance.
Engine oil must be drained when it is warm. Hot oil
can cause personal injury.
Figure 9.3 - Oil Drain Plug
Drain the oil only when it is hot and the contami-
nants are in suspension.
Operate the engine until the engine coolant tem-
perature reaches 140°F (60°C).
Shut the engine down and perform the lockout and
tagout procedure.
Place a suitably sized container beneath the oil
drain hose.
Disconnect the oil drain hose from the tractor frame
and lower the hose down near the container.
Remove the oil drain plug (1) and allow the oil to
drain into the container.
Protect the environment: handling and disposal of
used engine oil can be subject to federal, state and
local law regulation. Use authorized waste disposal
facilities, including civic sites and garages provid -
ing authorized facilities for the receipt of used en-
gine oil. If in doubt, contact your local authorities or
the EPA for guidance as to proper handling of used
engine oil.
Figure 9.4 - Engine Filter
Remove the filter and discard.
Place a small amount of oil around the gasket of
the filter.