Fayat Bomag CR 820 T Tier 4, Инструкция по эксплуатации, Инструкция по техническому обслуживанию

Страница: 104 / 130

9 Maintenance
Operations Manual
CR 820 T
Date May 2020
Page 9-6
Filters
The paver has five spin-on hydraulic fluid filters and
two suction strainers for maximum component pro-
tection. There are two travel circuit charge filters,
two conveyor drive charge filters, and one auxiliary
pump filter.
Two filters mounted underneath the aftertreatment
filter the fluid coming from the charge section of the
left travel and conveyor pumps through the filters
and back to their respective pumps.
Two filters mounted underneath the air cleaner filter
the fluid coming from the charge section of the right
travel and conveyor pumps through the filters and
back to their respective pumps.
There is one supercharged auxiliary filter located
on the left side of the paver underneath the after-
treatment. This filters the oil going into the auxiliary
pump when in stroke, otherwise the oil is sent back
to the tank.
Maintenance Procedures
Unless a procedure requires the engine to be run-
ning, perform the lockout and tagout procedure, as
described in the Emergency Procedures chapter,
before performing any inspections or maintenance
listed in this chapter.
When a procedure requires the engine to be run-
ning, Make sure all personnel are clear of the pav -
er and aware that the paver is going to be started.
Sound the horn three times to warn personnel..
Engine
Figure 9.1 - Engine
Check Engine Oil
The engine must be level when checking the oil
level to be sure the measurement is correct.
Figure 9.2 -Dipstick