Fantic Motor 125 Series, Руководство пользователя

Страница: 76 / 130

76
!"#$%#&''(#)'*#(''+&,!(-'#(+
!"#!$%
For the maintenance intervals, see page 61 (PE-
RIODIC MAINTENANCE CHARTS), under:
- idling.
To check the idling speed the vehicle engine
must be at normal running temperature. If the
check is made with a cool engine the calibration
will be out of tune.
&'(&)
- Run a few kilometres until normal operating
temperature is reached, then stop the vehi-
cle.
- Place it on the stand.
*+,-./+0-.123.32.324/5.35-.523.-1671-.8+039.
:735.;+0-.9,71<.+9.35-0-.79.35-.079,.2=.;4019>
?20,.=02@.35-.A-=3.97B-.2=.35-.C-57/A->
The engine idling speed must be approx.: 1250-
1500 rpm.
If the engine tends to cut out, without using the
throttle control, this means that the idling speed
must be adjusted using the screw located on the
carburettor.
D"EFG*H($*
- Adjust the screw (1) located on the carburet-
tor (left side).
- *!%'*($!$% (clockwise), the revs increase.
-
#IIG($!$%
(counter-clockwise), the revs
decrease.
To check correct operation and if the idling speed
remains stable, twist the accelerator handle to
accelerate and throttle down a few times.
$I*(J.
do not adjust the air adjusting screw to
avoid altering the mixture settings.
If necessary, consult a Dealer.
Keihin CVK30
there is the risk of burns to the skin.
ONLY remove the coolant cap (1)
when the engine is at ambient tem-
perature.
- Make sure that the engine is cold.
- Place the vehicle on the stand.
- Keep the vehicle upright with both wheels
resting on the ground.
- Turn the handlebar to the left.
- Unscrew (by turning counter-clockwise) the
filler cap (1) by about one turn.
- Wait for a few seconds to allow any pressure
in the system to be released.
- Unscrew the filler cap (1) by turning counter-
clockwise and remove it.
K!##.#(L(#.
Having removed the cap, if the coolant level is
visible and fully covers the plates, then it is in the
condition of “fill level”.
If this level has not been reached, the coolant
must be topped up.
Take great care when adding the liquid not to
exceed the “fill level”, otherwise there could be
overflow when the vehicle is running, which
could a ff ect operation.
If there is a high consumption of coolant, check
for leaks from the radiator or the pipe couplings.
Consult a KD$*!&.HI*IM Dealer for repairs.