Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 93 / 309

021 This error will be issued in the following cases:
> There is no block at the address defined by the parameter assigned to F18, F19, F20, F21, F22.
> The corresponding axis has not been defined in the addressed block
022 An axis is repeated when programming G74.
023 K has not been programmed after G04.
024 The decimal point is missing when programming T2.2 or N2.2.
025 Error in a definition block or subroutine call, or when defining either conditional or unconditional jumps.
026 This error is issued in the following cases:
> Memory overflow.
> Not enough free tape or CNC memory to store the part-program.
027 I//K has not been defined for a circular interpolation or thread.
028 An attempt has been made to select a tool offset at the tool table or a non-existent external tool (the
number of tools is set by machine parameter).
029 Too large a value assigned to a function.
This error is often issued when programming an F value in mm/min (inch/min) and, then, switching to
work in mm/rev (inch/rev) without changing the F value.
030 The programmed G function does not exist.
031 Tool radius value too large.
032 Tool radius value too large.
033 A movement of over 8388 mm or 330.26 inches has been programmed.
Example: Being the Z axis position Z-5000, if we want to move it to point Z5000, the CNC will issue
error 33 when programming the block N10 Z5000 since the programmed move will be:
Z5000 - Z-5000 = 10000 mm.
In order to make this move without issuing this error, it must be carried out in two stages as
indicated below:
N10 Z0 ; 5000 mm move
N10 Z5000 ; 5000 mm move