Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 207 / 309

8025/8030 CNC PROGRAMMING MANUAL 93
6.27.4. Preparation of a digitizing operation and later execution at the machine.
CONCEPTION OF THE SYSTEM. THE PROBE.
The probe can be fastened to the toolholder of the milling machine or machining center,
as if it were a tool, converting the machine tool into an automatic digitizing system.
The tip (interchangeable) of the needle of the probe is provided with a ball which is
threaded to the probe and follows the surface of the pattern during digitizing. Each probe
involves a family of tips with different ball radii for multiple applications.
The diameter of the ball of the needle or tip should be the same as the tool used in
subsequent machining.
The corrections of radii for other tools are also possible but another treatment of
the digitized program is required (G41, G42, G43).
The different probe needles have variable weights. In fact, in the probe system, needles
must have a maximum weight of 200 gm approximately to avoid possible errors of
interpretation of contact.
CALIBRATING THE PROBE
For this, we use the N01 cycle with which we determine the offset values for the probe,
which will be entered by the CNC in the corresponding corrector, which we have chosen
previously. (T00 by default.) The offset values are the error which may exist in the axes
of the main plane between the axis of the toolholder and the center of the measurement
probe ball.
In order to execute this cycle it is necessary to machine a hole beforehand, inside which
we will carry out the probings.
Once the hole has been made, the diameter and X,Y,Z coordinates of which we know (this
is due to that fact that we have chosen the place previously and moved to it with the CNC
jog controls) we change the tool for the probe and move in Z until we are inside the hole.
Next, we execute the N01 probe calibration cycle. Previously the programming format is
completed and the tool corrector is chosen where we want offset I,K to appear. T00
corrector is taken by default. All these operations can be done in TEACH-IN.
On exiting from the cycle the control automatically updates the I,K offset of the table and
the probe goes back to the starting point. Next we complete the rest of the information on
the table:
R: Radius of the ball
L: Length of the probe (depends on the zero part). If zero part is on the surface of
part, L will be zero also.