Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 120 / 309

6 8025/8030 CNC PROGRAMMING MANUAL
4. PROGRAM NUMBERING
Every program must be numbered between 0 and 99998.
This number must be entered at the beginning of the program, before the first block. If the
program is entered from an external peripheral, the symbol % is used, followed by the
number required and the pressing of LF or RT or both followed by the N of the first block.
5. PROGRAM BLOCKS
5.1. BLOCK NUMBERING
The block number is used to identify each of the blocks that make up a program.
The block number consists of the letter N followed by a figure between 0 and 9999. This
number must be written at the start of each block.
Blocks may be given any number between 0 and 9999 except that no block may be given
a lower number than the blocks preceding it in the program. It is advisable to avoid giving
blocks consecutive numbers, so that new blocks can be interposed where required.
If the CNC is programmed from its front panel, blocks are automatically numbered in steps
of 10.