Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 70 / 309

8025/8030 CNC OPERATING MANUAL 45
3.6.7.3. Assisted programming
Access to assisted programming is available in any of the program editing modes, i.e.
PLAY BACK (2), TEACH-IN (3) or EDITING (6). For this, if, during the writing of a
block the [HELP] key is pressed, the cursor which is found in the block to be written will
disappear and the screen will display:
PROGRAMMING GUIDE
1 - MOVEMENT PROGRAMMING
2 - CANNED CYCLES
3 - SUBROUTINES/JUMPS
4 - GEOMETRIC AIDE
5 - ARITHMETICAL FUNCTIONS
6 - G FUNCTIONS
7 - M FUNCTIONS
Pressing the desired number will display pages which explain the various functions
available to the CNC and how they are programmed. Once the appropriate page is
accessed, press the [HELP] key to continue writing the block. The cursor will reappear
and the information required will stay on the screen.
Supposing, for example, that when editing a program it is desired to program in a block
the canned cycle for rectangular pocket milling, the sequence will be:
Press [HELP]
Press 2
Press
Press 4
If the [HELP] key is then pressed, the cursor will appear and it becomes possible to write
the block, observing on the screen the meaning of the various parameters of the selected
function.
When the writing of the block is completed, pressing ENTER stores the block in the
memory and the standard display of editing modes will appear on the screen.
If, while any page of the assisted programming is on the screen, it is desired to return to
the standard display mode, there are two possibilities:
a) When nothing is written in the block, press RECALL if the cursor is displayed (if it
is not, press [HELP]).
b) When some information is already written in the block, if the cursor is displayed, press
ENTER or DELETE.