Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 63 / 309

38 8025/8030 CNC OPERATING MANUAL
The sequence to be followed is:
1- Press the [TOOL MEASUREMENT] key.
2- Select the tool to be measured by keying in: Txx.xx START.
3- Move the tool with the JOG keys up to a position close to the probe side to be touched.
4- Press the key of the axis to be measured (X or Z).
5- Press the JOG key that indicates in which direction the axis must be moved to carry out
the probing movement. The feedrate is established by P806.
6- Once the probing is done, the machine stops and the CNC loads in the corresponding
position of the tool offset table the X or Z value measured; setting to zero the K value.
7- Repeat from step 3 to measure and load the length of the tool in the other axis.
8 - Once the tool has been removed, repeat from point 2 for the measurement and loading of
the tools.
The FEEDRATE override knob has no effect during the probing movements and is set to
100%
The radius values of the R plate and the F shape factor of the tool are introduced manually by
means of mode o operation 8 or by means of programming the G50 function.
To go back to the JOG mode, press the [TOOL MEASUREMENT] key.
3.5.12. Spindle operating keys.
By means of these keys on the front panel, the spindle can be started in both directions as well
as stopping the spindle from turning, as long as the corresponding S has been programmed,
without need for executing M3,M4 or M5.
By means of the and keys it is possible to vary the S turning speed % program-
med.