Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 278 / 309

164 8025/8030 CNC PROGRAMMING MANUAL
P10: This parameter must be assigned a value other than "0" in order for the CNC to carry
out a final roughing pass prior to the finishing pass.
P13: Number of the first block to define the pattern.
P14: Number of the last block to define the pattern. It must be greater than P13.
Otherwise error code 13 is generated.
When programming this canned cycle the following should be borne in mind:
1. The distance between the starting point 0 and final point (B) along X generating error
31 when operating with tool compensation the value of this distance (from 0 to B)
should be equal to P7+NP5, N being an entire number (any multiple of P5).
2. The distance from 0 to A along Z axis should be higher than P8.
3. The definition of the pattern must not include point A because it is identified by P0
and P1.
4. The machining conditions (feedrate, spindle rotation, etc.) must be programmed
before calling the cycle. The parameters can be programmed in the calling block or
in previous blocks. The exit conditions are G00 and G90.