Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 94 / 309

034 S or F value too large.
035 Not enough information for corner rounding, chamfering or compensation.
036 Repeated subroutine.
037 Function M19 programmed incorrectly.
038 Function G72 programmed incorrectly.
It must be borne in mind that if G72 is applied only to one axis, this axis must be positioned at part zero
(0 value) at the time the scaling factor is applied.
039 This error occurs in the following cases:
> More than 15 nesting levels when calling subroutines.
> A block has been programmed which contains a jump to itself. Example: N120 G25 N120.
040 The programmed arc does not go through the defined end point (tolerance 0.01mm) or there is no arc that
goes through the points defined by G08 or G09.
041 This error is issued when programming a tangential entry as in the following cases:
> There is no room to perform the tangential entry. A clearance of twice the rounding radius or greater
is required.
> If the tangential entry is to be applied to an arc (G02, G03), The tangential entry must be defined in
a linear block.
042 This error is issued when programming a tangential exit as in the following cases:
> There is no room to perform the tangential exit. A clearance of twice the rounding radius or greater is
required.
> If the tangential exit is to be applied to an arc (G02, G03), The tangential exit must be defined in a
linear block.
043 Polar origin coordinates (G93) defined incorrectly.
044 Function M45 S programmed wrong (speed of the live tool).
045 Function G36, G37, G38 or G39 programmed incorrectly.
046 Polar coordinates defined incorrectly.
047 A zero movement has been programmed during radius compensation or corner rounding.
048 Start or cancel tool radius compensation while in G02 or G03.
049 Chamfer programmed incorrectly.
050 G96 has been programmed while the S output is in BCD as set by machine parameter. (AC spindle).