Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 92 / 309

001 This error occurs in the following cases:
> When the first character of the block to be executed is not an "N".
> When while BACKGROUND editing, the program in execution calls a subroutine located in the pro-
gram being edited or in a later program.
The order in which the part-programs are stored in memory are shown in the part-program directory.
If during the execution of a program, a new one is edited, this new one will be placed at the end of
the list.
002 Too many digits when defining a function in general.
003 A negative value has been assigned to a function which does not accept the (-) sign or an incorrect value
has been given to a canned cycle parameter.
004 A canned cycle has been defined while function G02, G03 or G33 was active.
005 Parametric block programmed wrong.
006 There are more than 10 parameters affected in a block.
007 Division by zero.
008 Square root of a negative number.
009 Parameter value too large
010 * The range or the Constant Surface Speed has not been programmed
011 More than 7 "M" functions in a block.
012 This error occurs in the following cases:
> Function G50 is programmed wrong
> Tool dimension values too large.
> Zero offset values ( G53/G59 ) too large.
013 Canned cycle profile defined incorrectly.
014 A block has been programmed which is incorrect either by itself or in relation with the program history
up to that instant.
015 Functions G14, G15, G16, G20, G21, G22, G23, G24, G25, G26, G27, G28, G29, G30, G31, G32, G50,
G52, G53, G54, G55, G56, G57, G58, G59, G72, G73, G74, G92 and G93 must be programmed alone
in a block.
016 The called subroutine or block does not exist or the block searched by means of special function F17
does not exist.
017 This error is issued in the following cases:
> Negative or too large thread pitch value.
> Synchronization factor K of the synchronized tool too large.
018 Error in blocks where the points are defined by means of angle-angle or angle-coordinate.
019 This error is issued in the following cases:
> After defining G20, G21, G22 or G23, the number of the subroutine it refers to is missing.
> The "N" character has not been programmed after function G25, G26, G27, G28 or G29.
> Too many nesting levels.
020 More than one spindle range have been defined in the same block.