Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 266 / 309

152 8025/8030 CNC PROGRAMMING MANUAL
G29 Conditional jump/call if equal or greater
When the CNC reads a block with G29, if the condition of equal or greater is met, it
jumps to the block identified by N4 or N4.4.2. If the condition of equal or greater is
not met, the CNC will disregard this block.
Programming: N4 G29 N4 or N4 G29 N4.4.2
G29 must stand alone in a block.
G30 Display of error code defined by K
When the CNC reads a block with G30, it stops the program and displays the error code
( see page 186, section 15.0 for possible error codes and messages).
Programming: N4 G30 K2
N4 : Block number
G30 : Code identifying programming of an error
K2(0-99) : Programmed error code
Any code between 0 and 99 can be programmed unless the error code K is defined by a
parameter (N4 G30 K P2) because then the possible values are 0-255.
This code, combined with G26,G27,G28,G29 enables the stopping of the program and the
detection of possible measuring error, for instance.
G30 must stand alone in a block.
Atention:
If it is not required for the CNC error code comment to be displayed, the
number of the code after G30 must be greater than those used by the CNC.
Remember also that the user can write comments in the program which
will be displayed when the corresponding block is executed.