Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 237 / 309

8025/8030 CNC PROGRAMMING MANUAL 123
11. M. MISCELLANEOUS FUNCTIONS
The miscellaneous functions are programmed by means of code M2.
96 different miscellaneous functions (M00-M99) can be programmed except
M41,M42,M43,M44 which are outputs automatically based on the spindle speed
programmed and the spindle ranges defined by parameters P7, P8, P9, P10 if P601(1) is
set to 1. If the parameter is set to 0, M41,M42,M43 must be programmed. The miscellaneous
functions come out in BCD code.
The CNC also has 15 decoded outputs for miscellaneous functions. These outputs will be
assigned to the required functions during the final adjustment of the CNC to the machine.
The miscellaneous functions which are not assigned a decoded output are always
performed at the beginning of the block in which they are programmed.
In assigning a decoded output to an miscellaneous functions, a decision is also made as to
whether it is to be performed at the beginning or at the end of the block in which it is
programmed.
Up to a maximum of seven miscellaneous functions may be programmed in one block.
When more than one miscellaneous function is programmed in a block, the CNC performs
then consecutively in the order in which they are programmed.
Some of the 100 miscellaneous functions have an internal meaning assigned to them in the
CNC.
11.1. M00. PROGRAM STOP
When the CNC reads code M00 in a block, it halts the program. Press the Cycle Start key
to continue.
It is recommended that this function be set in the table of decoded M functions so that it
is performed at the end of the block in which it is programmed (see Installation and Start
up Manual).