Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 251 / 309

8025/8030 CNC PROGRAMMING MANUAL 137
j) N4 P1 - OX
P1 takes the theoretical coordinate of the X axis, with respect to the machine zero where
the CNC is situated.
k) N4P1 = OC
P1 takes the theoretical coordinate of the C axis, with respect to the machine zero where
the CNC is situated.
l) N4P1 = OZ
P1 takes the theoretical coordinate of the Z axis, with respect to the machine zero where
the CNC is situated.
m) N4P1 = OW
P1 takes the theoretical coordinate of the 4th axis, with respect to the machine zero
where the CNC is situated.
n) N4P1 = OY
P1 takes the theoretical coordinate of the 3rd axis, with respect to the machine zero
where the CNC is situated.
In these last assignments, the measuring units taken by arithmetic parameter, depend
upon the value assigned to the machine parameter P611(6).
If we assign the value 1 to this machine parameter, when the assignment parameter
block is executed, of the P1 = 0X type:
P1 takes the value of the X coordinate, with respect to the machine zero point, either
in millimeters or inches, depending on the units of measure used.
Nevertheless, if we assign the value 0, when P1=0X is executed, P1 takes the value of
the X coordinate with respect to the machine zero, always in millimeters, without taking
into consideration the units of measure which are being used (mm or inches).
If any of the axes are ROTARY, the value taken by the parameter will always be in
degrees.
o) N4P1 = H (Value in HEXADECIMAL)
P1 takes the value in HEXADECIMAL indicated after H.
Possible values of H: 0/FFFFFFFF.