Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 182 / 309

68 8025/8030 CNC PROGRAMMING MANUAL
. Incremental loading of the values
Block N4 G5? (H+/-4.3) L+/-4.3 H+/-4.3 I+/-4.3 J+/-4.3 K+/-4.3 in mm or N4 G5? L+/-
3.4 H+/-3.4 I+/-3.4 J+/-3.4 K+/-3.4 in inches, increments by an amount H, I, J, K, the table
values indicated by G5? (G53-G59).
N4 : Block number
G5? : Zero offset code (G53, G54, G55,
G56, G57, G58, G59).
L+/-4.3 : Amount added or subtracted to the
L+/-3.4 V value previously stored in the table.
H+/-4.3 : Amount added or subtracted to the
H+/-3.4 W value previously stored in the table.
I+/-4.3 : Amount added or subtracted to the
I+/-3.4 X value previously stored in the table.
K+/-4.3 : Amount added or subtracted to the
K+/-3.4 Z value previously stored in the table.
Format b) To apply a zero offset to the current program.
According to the value assigned to the machine parameter P619(7) there are two cases:
Case 1) P616(4)=0
A block like N4 G5? is used to carry out a zero offset on the current program, according
to the values stored in the G5? position of the zero offset table (G53-G59).
N4 : Block number
G5?: (G53,G54,G55,G56,G57,G58,G59):
(Memory address in which the zero offset values are stored.)
Case 2) P616(4) = 1
When a function of the type G54 .... G58 is executed, the zero offset applied to each axis
will be the value indicated in the table (G54... G58) plus the value indicated in position
G59 of the table.
It does not affect G53.