Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 95 / 309

051 * "C" axis programmed incorrectly
054 There is floppy disk in the FAGOR Floppy Disk Unit or no tape in the cassette reader or the reader head
cover is open.
055 Parity error when reading or recording a cassette or a floppy disk.
056 This error comes up in the following cases:
> When the memory is locked and an attempt is made to generate a CNC program by means of function
G76.
> When trying to generate program P99999 or a protected program by means of function G76.
> If function G76 is followed by function G22 or G23.
> If there are more than 70 characters after G76.
> If function G76 (block content) has been programmed without having programmed G76 P5 or G76 N5
before.
> If in a G76 P5 or G76 N5 type function does not contain the 5 digits of the program number.
> If while a program is being generated (G76 P5 or G76 N5), its program number is changed without
cancelling the previous one.
> If while executing a G76 P5 type block, the program referred to is not the one edited. In other words,
that another one has been edited later or that a G76 P5 type block is executed while a program is being
edited in background.
057 Write-protected floppy disk or tape.
058 Problems in floppy disk movement or sluggish tape movement.
059 Communication error between the CNC and the FAGOR Floppy Disk Unit or cassette reader.
060 Internal CNC hardware error. Consult with the Technical Service Department.
061 Battery error.
The memory contents will be kept for 10 more days (with the CNC off) from the moment this error
occurs. The whole battery module located on the back must be replaced. Consult with the Technical
Service Department.
Due to danger of explosion or combustion: do not try to recharge the battery, do not
expose it to temperatures higher than 100°C (232°F) and do not short the battery leads.
064 * External emergency input (pin 14 of connector I/O1) is activated.
065 * This error comes up in the following cases:
> If while probing (G75) the programmed position is reached without receiving the probe signal.
> If while executing a probing canned cycle, the CNC receives the probe signal without actually carrying
out the probing move itself (collision).
066 * X axis travel limit overrun.
It is generated either because the machine is beyond limit or because a block has been programmed
which would force the machine to go beyond limits.
068 * Z axis travel limit overrun.
It is generated either because the machine is beyond limit or because a block has been programmed
which would force the machine to go beyond limits.
070 ** X axis following error.
071 ** Synchronized tool following error