Fagor 8025 T CNC, Руководство по эксплуатации

Страница: 192 / 309

78 8025/8030 CNC PROGRAMMING MANUAL
The exit conditions of all probing cycles are: G00, G07,G40,G90
The type of probe used in this cycles may be either one located in a fixed position on the
machine (used to calibrate the tools) or one placed on the turret (used to measure parts).
The latter probe will act as if it were a tool and must be calibrated prior to the execution
of the cycle and the X,Z,F,R, values entered in the appropriate tool table position.
While executing a probing canned cycle, if the CNC receives the probe signal without the
probing movement itself being executed, it will issue an error 65 stopping all axes(collision).
When the probe uses an infrared system to send the signal, it is necessary to indicate, with
machine-parameter P116, which M function must the CNC send to activate the probe.
This M function will be activated by the CNC at the beginning of the probing cycle and
must be cancelled by programming another M function.