AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a NetWare Server
23
Installing Additional Disks
◆
An ESD wristband is supplied with your storage system. To use
it, attach the clip of the ESD wristband (strap) to any bare
(unpainted) metal on the storage system; then put the wristband
around your wrist with the metal button against your skin.
◆
Use the ESD kit when handling any FRU. If an emergency arises
and the ESD kit is not available, follow the procedures in the
Emergency Procedures (Without an ESD Kit)
section.
Emergency Procedures (Without an ESD Kit)
In an
emergency
when an ESD kit is not available, use the following
procedures to reduce the possibility of an electrostatic discharge by
ensuring that your body and the subassembly are at the same
electrostatic potential.
These procedures are not a substitute for the use of an ESD kit.
Follow them only in the event of an emergency.
◆
Before touching any FRU, touch a bare (unpainted) metal surface
of the cabinet or storage system.
◆
Before removing any FRU from its antistatic bag, place one hand
firmly on a bare metal surface of the storage system, and at the
same time, pick up the FRU while it is still sealed in the antistatic
bag. Once you have done this,
do not
move around the room or
touch other furnishings, personnel, or surfaces until you have
installed the FRU.
◆
When you remove a FRU from the antistatic bag, avoid touching
any electronic components and circuits on it.
◆
If you must move around the room or touch other surfaces before
installing a FRU, first place the FRU back in the antistatic bag.
When you are ready again to install the FRU, repeat these
procedures.
