![background image](http://html1.mh-extra.com/html/elsner-elektronik/60121/60121_installation-and-operation-manual_2396633105.webp)
104
Basic Setting
Control System WS1 Color / WS1000 Color
• Version: 14.12.2016 • Technical changes and errors excepted.
Movement times
Press the buttons with the number values and enter the timed values (in seconds, see
top “Drive type”). If applicable, the movement time to zero position and the dead time
can be set. A keypad for setting appears. Confirm with the
OK
button.
The
movement time to zero position
defines how far the drive is extended after re-
traction (zero position). This helps e. g. to releave the cable of blinds (value e. g. 0.1 s).
The
dead time
defines how long it takes until an electronic drive starts moving after
the control relay has been closed. The setting of the dead time allows for a precise po-
sitioning of the drive, e. g. for slat tracking according to the solar position. Please fol-
low the advice of the drive manufacturer.
Settings
Different option settings appear here depending on the drive type:
Press the button to check the motor’s direction of rotation. A selection menu appears.
Test the response of the drive when pressing the
A/B
buttons. Then select the applica-
ble button
Retract with A
(or
Close with A
) or
Retract with B
(or
Close with B
).
Confirm your selection with the
OK
button.
ATTENTION
Rain and wind alarms are deactivated while this menu item is shown!
Press the button to adjust the assignment of arrow keys (Up/Down, Open/Closed). A
selection menu appears. Choose whether the drive should
retract
(or
open
) or
ex-
tend
(or
close
) when the button is pressed.
Confirm your selection with the
OK
button.
Extension time:
240,00
Retraction time:
240,00
Reversal time:
2,70
Time zero position:
0,00
Dead time:
0,00
Dir. of Rotation
Manual Direction