10 Communications
iConnect Installation Manual
56
10.1.5.
Account Number (not available for voice report)
To edit an account number:
1.
From the Programming menu, select Communications, Accounts [951].
2.
Select the account you want to program (1-6).
3.
From the account’s sub-menu, select Account Number [#5].
4.
Enter up to eight digits. Enter leading zeros for account numbers of less than eight digits. Use the key to enter
hexadecimal digits. Press '
√ʹ .
If the programmed protocol is Contact ID, "A" is not a valid entry in the account number.
10.1.6.
Call Attempts (not available for voice report)
The Call Attempts option determines the number of times the system tries to call a telephone number before moving on
to the next number in sequence.
To program the number of call attempts for an account:
1.
From the Programming menu, select Communications, Accounts [951].
2.
Select the account you want to program (1-6).
3.
From the account’s sub-menu, select Call Attempts [#6].
4.
Enter a value between 01 and 15. Press '
√ʹ.
10.1.7.
Account Type (not available for voice report)
To program the account type for an account:
1.
From the Programming menu, select Communications, Accounts [951].
2.
Select the account you want to program (2-6).
3.
From the account’s sub-menu, select Account Type [#7].
4.
Select Primary or Backup.
Account 1 is by default set as a primary account.
10.2.
Report Cycles
The system’s attempts to report events are organized in cycles. A report cycle is a set of call attempts – see p. 56,
10.1.6
Call Attempts (not available for voice report). If the system does not succeed in sending a report to any of the telephone
numbers, it tries to dial the entire report cycle again until it sends a successful report. You can determine the number of
times the system attempts to dial this sequence by programming the Report Cycle option.
To program the number of Report Cycles:
1.
From the Programming menu, select Communications, Accounts, Report Cycles [9517].
2.
Enter a value between 01 and 15. Press '
√ʹ.
In the example illustrated in Figure
10-1, Account 1 is programmed with 2 call attempts, Account 2 is programmed with
3 call attempts and the number of report cycles programmed is 3.
Figure
10-1: Typical Report Cycle Sequence
Содержание iconnect
