Electronics Line iconnect, Руководство по установке

Страница: 21 / 140

3 Basic System Operation
iConnect Installation Manual
17
3.6.3. Full Arming
Full arming is designed for when the occupant vacates the premises.
To fully arm the system using the front panel keypad or Wireless LCD Keypad:
1.
Check if the system is ready to arm.
2. Press the Full arming key on the keypad.
3. If One-Key Arming is disabled, enter your user code.
3.6.4. Part Arming
Part arming is designed for when the occupant intends to remain inside one part of the premises and secure another
part.
To partially arm the system using the front panel keypad or Wireless LCD Keypad:
1.
Check if the system is ready to arm.
2. Press the Part arming key on the keypad.
3. If One-Key Arming is disabled, enter your user code.
To partially arm the system using the hardwire LCD keypad:
1.
Check if the system is ready to arm.
2. Press PART on the keypad.
3. Select Part arming.
4. If One-Key Arming is disabled, enter your user code.
3.6.5. Perimeter Arming
Perimeter arming is designed for when the occupant intends to remain inside the premises and secure the perimeter.
To arm the system’s perimeter using the front panel keypad or Wireless LCD Keypad:
1.
Check if the system is ready to arm.
2. Press the Perimeter arming key on the keypad.
3. If One-Key Arming is disabled, enter your user code.
To arm the system’s perimeter using the hardwire LCD keypad:
1.
Check if the system is ready to arm.
2. Press PART on the keypad
3. Select Perimeter arming.
4. If One-Key Arming is disabled, enter your user code.
3.6.6. Combination Arming
The system allows you to activate a combination of two arming methods. If you Perimeter arm the system, you may
also activate Full or Part arming. Likewise, you can Perimeter arm the system after activating Full or Part arming. It is
not important which arming mode you choose first.
You can activate the second arming mode only during the exit delay of the first arming
mode. When the first exit delay expires, you cannot activate a second arming mode.
For combination arming, perform the following procedure:
1.
Check if the system is ready to arm.
2. Activate the first arming mode.
3. If One-Key Arming is disabled, enter your user code.
4. While the exit delay of the first arming mode is counting down, activate the second arming mode.
5. If One-Key Arming is disabled, enter your user code.
It is not possible to activate Full and Part arming modes simultaneously. It is necessary to
disarm first when changing from one arming mode to another arming mode.