22
EN
ESIM384 Installation and Configuration Manual v1.1
Installation Manual v1.0
Valid for ESIM384 v01.00
Safety instructions
Please read and follow these safety guidelines in order to maintain safety of operators and people around:
•
GSM alarm & management system eSIM384 (also referenced as “alarm system”, “system” or “device”) has radio transceiver operating in
GSM 850/900/1800/1900 bands.
•
DO NOt use the system where it can be interfere with other devices and cause any potential danger.
•
DO NOt use the system with medical devices.
•
DO NOt use the system in hazardous environment.
•
DO NOt expose the system to high humidity, chemical environment or mechanical impacts.
•
DO NOt attempt to personally repair the system.
•
System label is on the bottom side of the device.
GSM alarm system eSIM384 is a device mounted in limited access areas. Any system repairs must be done only by qualified,
safety aware personnel.
the system must be powered by main 16-24V ~50/60 Hz1.5A max or 18-24V
1,5A max power supply which must be
approved by LSt eN 60950-1 standard and be easily accessible nearby the device. When connecting the power supply to the
system, switching the pole terminals places does not have any affect.
Any additional devices linked to the system eSIM384 (computer, sensors, relays etc.) must be approved by LSt eN 60950-1
standard.
the power supply can be connected to AC mains only inside installation room with auto-
matic 2-pole circuit breaker capable of disconnecting circuit in the event of short circuit
or over-current condition. Open circuit breaker must have a gap between connections
of more than 3mm (0.12in) and the disconnection current 5A.
Phase
AC 230V
50/60Hz/DC 24V
USB cable
Null
PE
ESIM384
AC/DC
Mains power and backup battery must be disconnected before any installation or tuning work starts. the system installation
or maintenance must not be done during stormy conditions
Backup battery must be connected via the connection which in the case of breaking would result in disconnection of one of
battery pole terminals. Special care must be taken when connecting positive and negative battery terminals. Switching the
pole terminals places is NOt allowed.
In order to avoid fire or explosion hazards the system must be used only with approved backup battery.
the device is fully turned off by disconnecting 2-pole switch off device of the main power supply and disconnecting backup
battery connector.
Fuse F1 type – Slow Blown 2A. Replacement fuses have to be exactly the same as indicated by the manufacturer.
If you use I security class computer for setting the parameters it must be connected to earth.