EDWARDS SYSTEMS TECHNOLOGY IRC-3, Руководство по программированию

Страница: 139 / 284

Programming Manual 3.27
IRC-3 Data Entry Program Rev - 2.6
Using the IRC-3 Data Entry Program Rev. 2.6, perform the following
ZRM programming steps.
xx = ZRM panel address
PP = Priority value
[ ] = Alternate addresses for ZRM module installed in the lower (P6)
motherboard connector when a traditional card is installed in
the upper (P5) connector of the same motherboard
A. Define the ZRM in the database as a ZB8-8 module.
1) Entry Menu > 2) Enter Panel Configurations A [CM1N] or C
[CM2N]) Card Menu > 7) ZB8-8
B. Define ZRM module zones xx02[50], xx03[51], xx06[54], and
xx07[55] as class B supervised outputs, visual.
1) Entry Menu > 4) Enter Device/Zone Type > 1) Zone Menu > 9)
Visual zone, class B { xx02[50], xx03[51], xx06[54], and xx07[55]}
C. Define ZRM module zones xx01[49], xx05[53] as class B
supervisory zones
1) Entry Menu > 4) Enter Device/Zone Type > 1) Zone Menu > 3)
Supervisory Zone class B xx01[49], xx05[53]
D. Define ZRM module zone xx04[52] as a audible zone, class B.
1) Entry Menu > 4) Enter Device/Zone Type > 1) Zone Menu > 7)
Audible Zone, class B xx04[52]
E. NOTE: ZRM module zone xx08[56] is defined as a class B alarm
input zone by default. Do not change this setting.
F. Remove Disable Input Message Actions for zones xx01[49] through
xx07[55].
1) Entry Menu > 6) Enter Actions 9007 > A) Disable Input Message
{xx01[49], xx02[50], xx03[51], xx4[52], xx05[53], xx06[54], and
xx07[55]}
G. Define the zones/devices used to activate the ZRM module as alarm
zones. These may be traditional zones or individual analog devices.
Cross Zoned Release
Programming the ZRM for cross zoned operation is a two step process.
The first step is to program the zone responses to set the appropriate
first alarm output(s) on the ZRM module i.e. PPxx04[52] and/or
PPxx06[54]. Any other functions such as HVAC system control, and
operation of doors and dampers which must be performed upon the
initial alarm detection, should also be included in the zone response.
The second step is to use "AND functions" to "AND" all combinations
of devices/zones which are to set the ZRM automatic release sequence
output(s), i.e. PPxx03[51] and/or PPxx05[53]. Program the Manual
Release circuit response xx08[56] to activate the same systems and
devices programmed to operate on the first alarm zone.
firealarmresources.com