EDWARDS SYSTEMS TECHNOLOGY IRC-3, Руководство по программированию

Страница: 118 / 284

3.6 Programming Manual
1) Entry Menu > 4) Enter Device/Zone Types > 1) Zone Menu > 7)
Audible Zone Class A or B
The menu path to program a supervisory control module as an Audible
Zone is as follows:
1) Entry Menu > 4) Enter Device/Zone Types > 9) Audible Control
Module
9004 - Alarm Silence:
This action is generated whenever the ALARM SILENCE switch on the
CM1(N) is pressed. Audible circuits are automatically RESET with a
priority 50. This action is automatically built during the programming
process whenever a supervisory zone or a supervisory control module is
programmed as an audible zone.
9005 - Lamp Test:
This action is automatically generated by the system when the LAMP
TEST function is activated on the CM1(N) (i.e., Alarm Silence and
Trouble Silence switches pressed at the same time).
Note:
You must program Action 9005 to contain all LEDs you would
like to Lamp Test.
9006 - Regenerative Network Token Passing List:
This action will contain the list of all CM2N panels that will be
members of the Regenerative Network. CM2N panel addresses are
entered in the Activate Action entry of Action 9006. The 4-digit entry
represents two panel addresses. It is important that this action be multi-
resident in each of the CM2N panels on the list. There is a maximum of
32 panel addresses that can be defined in a regenerative network. The
panel address entered into Action 9006 is only the base panel address of
the CM2N. Additional addresses in a CM2N required by ZAS-1 cards
are accounted for.
9007 - Messages Disable During Alarm:
This action is automatically generated by the system when in alarm.
Any zone that is defined as an audible or visual zone is affected by this
action. All audible and visual zones' messages will be disabled by this
action upon alarm condition and will remain disabled until after all
system components are restored. This function will prevent printing
restorations of audible and visual circuits after system reset.
9008 - Sensor Maintenance Alert:
This action is automatically generated by the system when any photo-
electric or ionization analog sensor reaches a maintenance level of
detection.
9009 - Point Verification:
This action is automatically generated by the system when any point
defined as "verified" is in the verification process.
9010 - Status Zones:
This action will define zones or devices in the system identified as
status zones. When a point is identified as a status zone in Action 9010,
firealarmresources.com