EDWARDS SYSTEMS TECHNOLOGY IRC-3, Руководство по программированию

Страница: 127 / 284

Programming Manual 3.15
9068 8th position 9084 24th position
9069 9th position 9085 25th position
9070 10th position 9086 26th position
9071 11th position 9087 27th position
9072 12th position 9088 28th position
9073 13th position 9089 29th position
9074 14th position 9090 30th position
9075 15th position 9091 31st position
9076 16th position 9092 32nd position
Note:
If a particular CM2N does not require the ability to interact with
other serial annunciators, the Action (9061 through 9092) that
corresponds to that CM2N's panel address entry position in Action
9006 is not defined.
Action # 90xx ( xx = 61 through 92; see above table and match
position to Action #)
Multi-resident panel addresses yy (yy = panel address of CM2N whose
list this Action is defining, and other panel addresses associated with
the CM2N of this Action (i.e., one or two ZAS-1 cards in the panel)
will be accounted for.
Activate Action [SAN Panel Addr.][SAN-COM Priority]
Activate Action [SAN Panel Addr.][SAN-COM Priority]
The SAN panel address entered into each activate action line of Action
90xx represents the serial annunciator panel address(es) that CM2N
panel yy will communicate with in the regenerative mode. The SAN-
COM priority determines how the CM2N yy will react to operation of
SAN-COM switch activations in the regenerative mode.
The following priority entries pertain to SAN-COM Input Zone
addresses 01 through 08. In a regenerative mode, all other SAN option
module switch input zones and output LEDs or relays will operate as
programmed in the IRC-3 data entry program.
Priority 00 = No response to SAN-COM switch activations
Priority 01 = Response to ALL SAN-COM switch activations
Priority 02 = Response only to the SAN-COM reset switch
Example #3:
The same building complex used in Example #2 will be used in this
example with the addition of four serial annunciators. An IRC-3 single-
line network is used to protect five buildings of a complex.
Bldg. #1 - CM1N panel address 01
No SAN panel in this building
Bldg. #2 - two CM2Ns with panel addresses 05 and 09
SAN panel address 20; includes SAN-COM module but only
RESET function to operate from SAN-COM in this building
Bldg. #3 - one CM2N with panel addresses 13
firealarmresources.com