EDWARDS SYSTEMS TECHNOLOGY IRC-3, Руководство по программированию

Страница: 117 / 284

Programming Manual 3.5
Actions
A number of actions have dedicated functions in the network. These
actions are:
9000 - Guard Patrol Alarm:
This action is automatically generated by the system whenever a patrol
route has been terminated due to an out of time or out of sequence
signal. When using Guard patrol you must program a message with this
action. This message must indicate "PATROL ALARM".
9001 - Printer Fault:
This action is automatically generated by the system whenever the
computer cannot transmit to the printer. This action may be disabled
through the Panel Configuration Menu of the program in systems not
requiring a printer (non NFPA 72D systems) as indicated by the
following path:
1) Entry Menu > 2) Enter Panel Configurations > 1) Printer Disable
Note:
The printer port must be enabled when using the VDU-3 or CDR-
3 options.
9002 - Reset:
This action is automatically generated by the system whenever the
Reset switch is pressed on the CM1(N), RMDP-1N, ACP, or SAN-
COM (which has been Enabled for automatic operation). Also,
activating relay address xx0197 will generate a system-wide broadcast
Reset.
The Reset period for the IRC-3 single-line system is variably dependent
on the number of panel addresses that are defined in the program,
including the 4 panel addresses of the CM1N/RMDP-1N.
Number of Defined
Panel Addresses
Reset Period
1-10 35 seconds
11-20 40 seconds
21-30 50 seconds
31-56 60 seconds
9003 - Drill/All Call:
This action is generated whenever the DRILL/ALL CALL switch on the
CM1N is pressed or whenever the ALL-CALL switch on the ACP is
pressed. This action is automatically built during the programming
process whenever a supervisory zone or a supervisory monitor module
is programmed as an audible zone. All audible circuits are
automatically SET with a priority 50.
The menu path to program a standard zone as an Audible Zone is as
follows:
firealarmresources.com