12
5.3.5.2 Hard Copper Plumbing Method
If the water supply connection must be copper tubing, the territory
manager will be responsible for the correct pipe fittings and
connectors to complete the installation. The water supply line must be
a minimum 3/8” copper tube.
Do not solder the inlet connection,
damage to the regulator may occur
.
Note: To save time, you should now dock a product capsule and
initiate dissolution cycle (see section 6). The remaining installation
procedures can be performed while the tank is filling.
5.3.6 Product-delivery Tube Connection
A 1/2” OD PE tube (8501-5139) is used to deliver the detergent to each
laundry machine. It is important that the outlet tubing DOES NOT exceed
50’ (15 meters) under normal installation.
1. Locate the three ½” tubes on the back of the dispenser (see fig
5.3.5.1). The tube for laundry machine #1 is located on the left,
washing machine #2 is in the middle and machine #3 is on the right
(as viewed from behind). Connect 1/2” PE tubing to discharge tubes
(mentioned above) using the ½” union connector located in the
installation kit. A plug was put on the line for machine #3 at the
factory. This is done to prevent leaking from this line in accounts with
only two washers. If connecting to a third washer, remove the plug
assembly from the tube. If the tube is crimped from the plug, cut the
tube just behind the crimp to ensure that the union connector will
make a good seal.
Note: Tubes must be inserted ~0.75” for
proper engagement. Tubes not being connected to washers
should be kinked and secured with a cable tie to plug. Do not
shorten.
Fig 5.3.5.1
