Eaton APS12-300 Series, Инструкция по установке и эксплуатации

Страница: 26 / 120

Access Power Solutions Installation and Operation Guide (APS6-300/500 and APS12-300 Series)
18
Copyright © 2007-2013 Eaton Corporation. All Rights Reserved.
IPN 997-00012-49G May 2013

Servicing and Maintenance

The APS contains hazardous voltages and hazardous energy levels. Before undertaking any maintenance
task refer to the Warnings on page
16 .

If a maintenance task must be performed on a "live" system then take all necessary precautions to avoid
short-circuits or disconnection of the load equipment, and follow any "live-working" instructions
applicable to the site.

Only perform the maintenance tasks described in the Maintenance chapter. All other tasks are classified
as Servicing. Servicing must only be performed according to specific instructions and only by personnel
authorized by Eaton. This includes disassembly and/or servicing of any modules.

For further information on Servicing contact your local Eaton dc product supplier, or refer to the contact
details on page
107 .

EMC Compliance

This dc power system may be used in close proximity to other electronic equipment, provided
installation is carried out according to instructions in this guide. However, proper installation and
compliance with EMC standards does not guarantee that the dc power system will not respond to
electromagnetic disturbances, or will not cause interference to other equipment in a particular
installation.

In a domestic environment this product may cause radio interference in which case the user may be
required to take adequate measures.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.
Inspecting the Equipment and Reporting Damage
Unpack the equipment and inspect it carefully for possible damage that may have occurred
while in transit. Do not use any damaged equipment.
Report any damage immediately, using a completed Equipment Incident Report on page
105 .

Keep the original packaging to use if any item needs to be returned for replacement or repair.