Access Power Solutions Installation and Operation Guide (APS6-300/500 and APS12-300 Series)
62
Copyright © 2007-2013 Eaton Corporation. All Rights Reserved.
IPN 997-00012-49G May 2013
Step 4 - Download the configuration file
1
Connect to the system controller with
DCTools/Web
. See details on page
System Controller Operation Handbook.
2
If a copy of the old configuration file, or a master configuration file is available,
then use
DCTools
to restore (download) it to the new system controller.
See Backup and Restore on page
in the System Controller Operation Handbook.
If you receive an error message about the MIB file version, please contact your
Eaton dc product supplier for advice.
3
If a copy of the old configuration file, or a master configuration file is not
available, then use the keypad or
DCTools/Web
to change the configuration
settings to the correct values (provided the system controller is set for the correct
nominal system voltage).
Step 5 - Check the system controller operation
1
Map the I/O board (SC200 only):
In DCTools/Web go to:
RXP
.
Copy the I/O board serial number(s) from the
RXP Devices
table to the
I/O
Board to Serial Number Mapping
table to map an
IOB Number
to each I/O board
(overwrite an existing serial number if required).
If multiple SiteSure-3G modules are connected use the I/O board Identify function
to physically identify each module. See details in the System Controller Operation
Handbook.
2
Check that the system controller has registered all rectifiers.
3
Check all control processes, alarms and current measurement(s).
4
Check the power system identification parameters and communications settings.
5
Change the configuration file as required to ensure that the system controller
operates as intended.
6
Check the system controller time (SC200 only). See details in the System
Controller Operation Handbook.
