Eaton APS12-300 Series, Инструкция по установке и эксплуатации

Страница: 41 / 120

Installation
Copyright © 2007-2013 Eaton Corporation. All Rights Reserved.
IPN 997-00012-49G May 2013
33
Step 3 - Set up SC200 or SC100
Configure the inputs and outputs after completing the installation and all the Startup
Tasks on page
36 .

For configuration details refer to Digital Inputs and Digital Outputs in the System
Controller Operation Handbook (see Related Information on page
i ).
Step 4 - Refit top cover (if removed)
Replace the top cover (if fitted and all installation tasks are completed).
Procedure complete
Task 9 - Connect Additional Input/Output (if required - SC200 only)
If additional input/outputs are required then SiteSure-3G modules can be connected to the APS
(SC200 only). A SiteSure-3G input/output module has the following features.
SiteSure-3G
Digital Inputs 10
Digital Outputs (relays) 6
Analog Inputs (0 to 10V) 4
Current Sense Inputs 3
Temperature Sense Inputs 2
Bus Voltage Input (0-60V) 1
Enclosure Wall or panel mounting plastic case
For further information refer to the SiteSure-3G Installation and Operation Guide (see Related
information on page
i ).

Connect the SiteSure-3G cable to a spare RJ45 socket (S1, S2 or S3) on the Voltage Feed Module
board. See the diagram on page
3 (APS6 models) or the diagram on page 6 (APS12 models) for
socket location.
Task 10 - Connect to the AC Supply Point


A suitably qualified electrician familiar with local wiring regulations must carry out the ac
connection.
Step 1 - Replace all covers on the APS