Doosan DX190W, Руководство по эксплуатации и обслуживанию

Страница: 83 / 315

OP000528
2-15
Operating Controls
12. Cabin Work Light Switch (Optional)
This switch is used to control the cabin work lights, if unit is
equipped with them.
O. In this position, all cabin work lights are turned "OFF."
I. In this position, the front cabin work lights on the front
top of cabin will turn "ON."
II. In this position, the front cabin work lights on the front
top of cabin and rear cabin work lights on rear top of
cabin will turn "ON."
13. Lower Wiper Switch (Optional)
This switch is used to control the lower front window wiper.
O. In this position, lower windshield wiper is "OFF."
I. In this position, lower windshield wiper runs at a
constant speed.
NOTE: Operating wiper without washer fluid or when
there is sand or dirt present will damage the
window and wiper.
WARNING!
Set the parking brake switch in the "I"(APPLIED)
position before leaving the excavator.
Make sure to "APPLY" the parking brake switch before
trying to start the excavator.
CAUTION!
Do not use the parking brake to stop the excavator,
except in an emergency; otherwise, it might cause
premature wear or damage of the brake.
FG000026
O
I
II
Figure 19
Figure 20
O
I
FG000028