Doosan DX190W, Руководство по эксплуатации и обслуживанию

Страница: 33 / 315

OP000527
1-27
Safety
MACHINE OPERATION
When Swinging or Changing Direction of
Travel
Before operating the machine or the work equipment, always
observe the following precautions to prevent serious injury or
death.
• Start and operate the machine only while seated.
• When changing the direction of travel from forward to
reverse or from reverse to forward, reduce speed
early and stop the machine before changing the
direction of travel.
• Sound the horn to warn people in the area.
• Check that there is no one in the area around the
machine. There are blind spots behind the machine,
so if necessary, swing the upper structure to check
that there is no one behind the machine before
traveling in reverse.
• When operating in areas that may be hazardous or
have poor visibility, designate a person to direct work
site traffic.
• Ensure that no unauthorized person can come within
the turning radius or direction of travel.
Be sure to observe the above precautions even if a travel alarm
or mirrors are installed.
Travel Precautions
Never turn the starting switch to the "O" (OFF) position when
traveling. It is dangerous if the engine stops when the machine
is traveling. It will be impossible to operate the steering.
Attachment control levers should not be operated while
traveling.
Do not change selected travel mode (FAST/SLOW/CLEEP)
while traveling.
Fold in work equipment so that the outer end of the boom is as
close to the machine as possible, and is 40 ~ 50 cm (16 ~ 20 in)
above ground.
Never travel over obstacles or slopes that will cause the
machine to tilt severely. Travel around any slope or obstacle that
causes the machine to tilt 10 degrees or more to the right or left,
or 30 degrees or more from front to rear.
Do not operate the steering suddenly. The work equipment may
hit the ground and cause the machine to lose its balance, and
this may damage the machine or structures in the area.
HGB1014L-1
Figure 17
FG006536
40~50cm
Figure 18