590
Appendix
THIS MODEL PHONE MEETS THE U.S. GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone contains a radio transmitter and receiver. Your phone is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S.
Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general
population. The guidelines are based on standards that were developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies.
The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate
(SAR). The SAR limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted using standard operating positions accepted
by the FCC with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the
maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the output.
Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed
the limit established by the U.S. government-adopted requirement for safe exposure. The tests are performed on position
and locations (for example, at the ear and worn on the body) as required by FCC for each model. The highest SAR value for
this model phone as reported to the FCC when tested for use at the ear is 0.33W/kg, and when worn on the body, is 0.05W/
kg. (Body-worn measurements differ among phone models, depending upon available accessories and FCC requirements).
While there may be differences between the SAR levels of various phones and at various positions, they all meet the U.S.
government requirement.
The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be
found under the Display Grant section at http://www.fcc.gov/oet/fccid after search on FCC ID A98-FOMA-N900IG.
For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines when used with an
accessory designated for this product or when used with an accessory that contains no metal and that positions the handset
a minimum of 1.5 cm from the body.
In the United States, the SAR limit for wireless mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over
one gram of tissue. SAR values may vary depending upon national reporting requirements and the network band.
This model phone FOMA N900iG meets the MIC’s* technical regulation for exposure to radio waves.
The technical regulation established permitted levels of radio frequency energy, based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation of scientific studies. The regulation employs a
unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit is 2 watts/kilogram (W/kg)** averaged
over ten grams of tissue. The limit includes a substantial safety margin designed to assure the safety of all persons,
regardless of age and health. The value of the limit is equal to the international guidelines recommended by ICNIRP***.
All phone models should be confirmed to comply with the regulation, before they are available for sale to the public. The
highest SAR value for this model phone is 0.296W/kg. It was taken by the Telecom Engineering Center (TELEC), a
Registered Certification Agency on the Radio Law. The test for SAR was conducted in accordance with the MIC testing
procedure using standard operating positions with the phone transmitting at its highest permitted power level in all tested
frequency bands. While there may be differences between the SAR levels of various phones and at various positions, they
all meet the MIC’s technical regulation. Although the SAR is determined at the highest certified power level, the actual SAR
of the phone during operation can be well below the maximum value.
For further information about SAR, please see the following websites:
World Health Organization (WHO) : http://www.who.int/peh-emf/
ICNIRP : http://www.icnirp.de/
MIC : http://www.soumu.go.jp/english/index.html
TELEC : http://www.telec.or.jp/ENG/Index_e.htm
NTT DoCoMo : http://www.nttdocomo.co.jp/ (Japanese only)
NEC : http://www.n-keitai.com/lineup (Japanese only)
Ministry of Internal Affairs and Communications
The technical regulation is provided in Article 14-2 of the Ministry Ordinance Regulating Radio Equipment.
International Commission on Non-Ionizing Radiation Protection
SAR certification information
Radio Frequency (RF) Signals
SAR Certification and Other Information
Содержание foma N900IG
