Digital Monitoring Products
XTLplus International Series Installation and Programming Guide
16
NETWORK OPTIONS
Network Options are provided to define the network configuration for the panel. This information will be used during
communication of messages via network. Wi-Fi must be selected as Communication Type in the Communication
section for Wi-Fi Setup to display.
IP addresses and port numbers may need to be assigned by the network administrator. When entering an IP,
Gateway, or Subnet Mask address be sure to enter all 12 digits and leave out the periods. For example, IP address
192.168.000.250 is entered as 192168000250.
Network Options
This option is for configuring the desired network settings. Press any select area to
select.
Wi-Fi Setup
This option is for connecting to the desired Wi-Fi network and displays when Comm
Type is set to Wi-Fi. Press any select area to select.
WPS LIST MANUAL displays. Press the first select area to choose WPS to automatically
connect to a WPS enabled router. Press the second select area to choose LIST and see
the name and signal strength of any Wi-Fi routers in range. Press the third or fourth
select area to choose MANUAL and enter the name of the Wi-Fi router you wish to
connect to. Press CMD to display TEST. To select TEST press the first select area to verify
connection of your system to the Wi-Fi network.On Graphic Touchscreen Keypads with
Version 110 or higher connected to a panel running Version 172 or higher, a Wi-Fi status
icon will display at the top of the keypad when the system is connected to the network.
WPS
When WPS is selected, SEARCHING displays. Press the WPS button on the Wi-Fi
network router to which you are attempting to connect. SEARCHING displays for up
to two minutes or until connected to the WPS enabled router. Refer to the router’s
instruction manual for sending a security key to the XTLplusINT Series panel.
If the panel fails to connect to the WPS enabled router, WPS FAILED RETRY? NO YES
displays. Press the fourth select area to RETRY or press the third select area to display
WPS LIST MANUAL.
List
When LIST is selected, SEARCHING displays until any Wi-Fi networks are found in range.
Once available Wi-Fi networks are found the keypad displays the name of the SSID (Wi-
Fi Network name) and signal strength of each network. Press
CMD
to scroll through the
list of available Wi-Fi networks. When the desired network is displayed, press any select
area to connect.
If the panel is unable to detect the security type, W/L SECURITY with the default
security type WPA-PSK displays. If a different security type is required, press
CMD
and
WEP WPA NONE displays. Press the select area of the desired security type to choose.
When connecting to the Wi-Fi network the panel also detects the security type in use
and W/L KEY: *************** displays.
Enter the W/L KEY and the panel performs a connection test and CONNECTING
displays. When successful, CONNECTED displays on the keypad. If the panel does not
connect to the Wi-Fi network, NOT CONNECTED displays. Press
CMD
to return to the
WIFI SETUP main screen.
Manual
This option allows you to enter the desired network name using the keypad. When
MANUAL is selected, the current settings display. Press
CMD
to continue with no
change. SecureCom is the default.
Use the number keys on the keypad to enter a new or different SSID (Wi-Fi Network
name), there is no need to press a select areas. Once the SSID is entered, press
CMD
and
SEARCHING displays.
NETWORK OPTIONS
SEARCHING
SEARCHING
MANUAL
WIFI SETUP
ENTER SSID
