DH Instruments E-DWT-H, Руководство по эксплуатации и обслуживанию

Страница: 81 / 126

3. OPERATION
Page 71 © 2009 DH Instruments, a Fluke Company
3.9.9.3 <3ATEST>
 PURPOSE
•
Resets Auto Tests to default values (see Section 3.7.11).
•
Clears File AutoTest definition files (see Section 3.8.5.2).
•
Clears AutoTest results data logs (see Section 3.8.5.1).
3.9.9.4 <4 Cal>
 PURPOSE
Note
The Reset - Cal function will reset the Q-RPT and barometer
calibration coefficients and reset AutoZ values to zero. This will
change the RPM4-E-DWT calibration and could cause it to make
out of tolerance measurements.
Clears all user values affecting the calibration of Q-RPTs and the on-board
barometer. The Reset – Cal resets are itemized in Table 10.
Table 10. Reset – Cal
RESET RESULT SEE SECTION
All Q-RPT calibration
coefficients PA to zero, PM to 1 5.3.1.1
On-board barometer
calibration coefficients PA to zero, PM to 1 5.2.2
Calibration date Set all dates to 19800101 5.3.7, 5.2.2
AutoZ value 101325 Pa
Gxxx, BGxxx Q-RPTs: All P
offset
values to zero
3.9.1
AutoZ function ON, all Q-RPTs 3.9.1
3.9.9.5 <5 All>
 PURPOSE
Note
The reset - all function clears and deletes large amounts of user
defined information including critical calibration data.
Combines all resets in one global reset command that clears the entire user
section of non-volatile memory except the ID function (see Section 3.9.5.4) and
the security level password (see Section 3.9.5.5) returning RPM4-E-DWT to the
“as delivered” condition. The Reset – All resets are itemized in Table 11.
Table 11. Reset – All
RESET RESULT SEE SECTION
Reset – Sets All the resets of Reset - Sets 3.9.9.1
Reset – Units All the resets of Reset - Units 3.9.9.2
Reset – Atest All the resets of Reset - ATest 3.9.9.3
Reset – Cal All the resets of Reset - Cal 3.9.9.4
Remote Interfaces COM1, COM2 interfaces to default settings. 3.9.2
Remote Communications Remote command format to Classic 3.9.2.3
Level (Security) Reset security level to low 3.9.5.5